April 5, 2026: LEMON Manuals is launched! Read the announcement.

Basic Diagnostic Procedure: Procedure

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation.
Registration of the immobilizer is necessary after the replacement of the control module, etc. For detailed procedure, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".

NOTE:

To check harness for open or short circuits, shake the suspected trouble spot or connector.
Check List for Interview < Ref. to CHECK LIST FOR INTERVIEW . >

Step	Check	Yes	No
1 CHECK PRE-INSPECTION. Ask the customer when and how the trouble occurred using the interview check list. < Ref. to CHECK LIST FOR INTERVIEW . >	Did you interview the customer?	Go to step 2.	Interview the customer.
2 BASIC INSPECTION. Check components which might affect body control. < Ref. to INSPECTION , General Description. >	Is the component that might influence the body control problem normal?	Go to step 3.	Repair or replace each component.
3 CHECK DTC. Read the DTC. < Ref. to OPERATION , Read Diagnostic Trouble Code (DTC). > NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. < Ref. to COMMUNICATION FOR INITIALIZING IMPOSSIBLE , Subaru Select Monitor. > Record all DTCs, time stamp and freeze frame data. NOTE: For time stamp, refer to "LAN SYSTEM". < Ref. to TIME STAMP , CAUTION, General Description. >	Is DTC displayed on Subaru Select Monitor?	Go to step 5.	Go to step 4 .
4 PERFORM GENERAL DIAGNOSTICS. Inspect using the "General Diagnostic Table". < Ref. to GENERAL DIAGNOSTIC TABLE . >	Is result of inspection OK?	The body control system is normal.	Go to step 5 .
5 PERFORM DIAGNOSIS. Correct the cause of trouble. Perform the Clear Memory Mode. < Ref. to OPERATION , Clear Memory Mode. > Read the DTC. < Ref. to OPERATION , Read Diagnostic Trouble Code (DTC). >	Is DTC displayed on Subaru Select Monitor?	Repeat step 5 until DTC is not shown.	Finish the diagnosis.