Unit Inspection
WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Preparation tool:
Circuit tester
- Connect three dry cell batteries (1.5 V) in series.
- Connect the (+) side of the battery to terminal No. 3 of the sensor, and the (-) side of the battery to terminal No. 1, and apply a voltage of 4.5 V between terminals No. 3 - No. 1.
- With voltage applied, check the voltage between terminals when the sensor link is moved slowly up and down.
Terminal No. Inspection conditions Standard 2 (+) - 1 (-) Move the link within the operation range. 0.5 - 4.1 V - Replace the sensor assembly - headlight beam leveler if the inspection result is not within the standard value.