Push Button Ignition Switch: Inspection

On the vehicle inspection 

Preparation tool: 

Circuit tester 

1. Check the continuity between push button ignition switch terminals.

   Terminal No.	Inspection conditions	Specification	Connection diagram
   4 (COM) - 5 (GND)	Always	Continuity exists	Courtesy of SUBARU OF AMERICA, INC.
   7 (SSW1) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists	Courtesy of SUBARU OF AMERICA, INC.
   2 (SSW2) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists	Courtesy of SUBARU OF AMERICA, INC.

2. Check the push button ignition switch operation when battery voltage is applied between the terminals of the push button ignition switch.

   Terminal No.	Inspection conditions	Specification	Connection diagram
   11 (SWIL) - 5 (GND)	Connect battery to the terminals	Goes off → Red switch illumination light	Courtesy of SUBARU OF AMERICA, INC.
   12 (INDS) - 5 (GND)		Turns off → Switch indicator lights in green	Courtesy of SUBARU OF AMERICA, INC.
   13 (INDW) - 5 (GND)		Turns off → Switch indicator lights in orange	Courtesy of SUBARU OF AMERICA, INC.

3. Replace the push button ignition switch if the inspection result is not within the standard value.