System Operation Check Mode: Operation

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Keyless access system}.
On «Keyless access system» display, select {Work Support}.
Select {System Operation Check Mode}.
Select the check point and click [OK].
Select [Exit] to exit the drive item mode. The screen will return to the «Drive item» screen.

NOTE: Each output check continues to run for five seconds before stopping automatically.

Data

Keyless access CM output check

Remarks

Tuner power supply ON (indoor tuner)

Output

Perform the power supply check for the receiver.

Stop

Driver seat sensor power supply

Output

Perform check of the power supply for the driver's seat sensor.

Stop

Passenger seat sensor power supply

Output

Perform check of the power supply for the passenger's seat sensor.

Stop

STSW

Output

Turn on the STSW. ⁽²⁾

Stop

IGN2

Output

Turn on the IGN2.

Stop

IGN1

Output

Turn on the IGN1.

Stop

ACC

Output

Turn on the ACC.

Stop

Start SW character illumination lighted

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Start SW indicator lighted (green)

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Start SW indicator lighted (orange)

Output

Perform ON output of the push button ignition switch back-up light. ⁽¹⁾

Stop

Steering lock power supply

Output

Output power supply signal from power supply CM to steering lock CM.

Stop

⁽¹⁾	When lit by a condition other than for a system operation check mode, it will not become unlit even when set to OFF or no output.

⁽²⁾	When performed with IGN ON, engine will start. Therefore, great care must be exercised.

NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".