Power Window Control Switch: Inspection: Sub-Switch

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Remove the switch - power window sub front.

Check the resistance between terminals of the switch - power window sub front.

Fig 1: Checking Resistance Between Terminals Of Power Window Sub Front Switch

Courtesy of SUBARU OF AMERICA, INC.

	Terminal No.	Inspection conditions	Standard
Passenger seat, rear	6 - 5 8 - 7	UP	Less than 1 Ω
	7 - 6 4 - 6	OFF	1 MΩ or more
	5 - 4 8 - 7	OFF	Less than 1 Ω
	6 - 8 5 - 4	DOWN	Less than 1 Ω

If the inspection result is not within the standard, replace the switch - power window sub front.