Engine Control Module (ECM): Installation
Install in the reverse order of removal.
CAUTION:
- When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".)
- When the ECM has been replaced, be sure to perform the ACTGS calibration operation (perform ACTGS control system operation inspection). < Ref. to OPERATION , System Operation Check Mode.>
- If replacing ECM or the bracket, replace both parts with new parts at a time.
- After installing the bracket to ECM, do not separate the bracket.
- If the bracket has been installed to ECM in the wrong direction, replace both parts to new parts.
NOTE:
When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.
Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)