Steering Column: Installation
CAUTION:
If the steering wheel and steering angle sensor are removed, perform "VDC SENSOR MIDPOINT SETTING MODE
" of the VDC. < Ref. to
ADJUSTMENT
, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U). >
- Install the grommet to the toe board.
- Insert the end of the column assembly - steering into the toe board grommet.
- Tighten the column assembly - steering installation nut located under the beam COMPL - steering with the tilt lever fixed.
Tightening torque:
20 N.m (2.04 kgf-m, 14.8 ft-lb)
- Connect all connectors located under the beam COMPL - steering.
- Connect the horn harness and airbag connector, and install the airbag module.
- Install the knee airbag module.
- Install the cover assembly - instrument panel LWR driver INN and OUT.
- Install the universal joint assembly - steering. < Ref. to
INSTALLATION , Universal Joint. >CAUTION:
- Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.
- Align the center position of the steering roll connector. < Ref. to ADJUSTMENT , Roll Connector. >
- Install the steering wheel. < Ref. to INSTALLATION , Steering Wheel. >