Stop Light Switch: Installation
WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stop light switch onto the bracket with screws and position it with the nut.
- Adjust the stop light switch position, and then tighten the nut. < Refer to
ADJUSTMENT , Stop Light Switch. >
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Install the panel - knee guard.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >