LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> Outback 2.5i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (Diagnostics) (H6DO) - Introduction) >> Inspection Mode >> Procedure >> SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

SUBARU Select Monitor

WARNING: This page is about a different variant/trim than selected.
  1. Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE .>
  2. Read the diagnostic trouble code (DTC) and check that no DTC is displayed. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .> After solving the DTC, repeat from step  1).
  3. Start the engine, and run the engine at idle for 10 seconds or more.
  4. Read the diagnostic trouble code (DTC) and check the DTC. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) .>
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .> After solving the DTC, repeat from step  1).
scientia non olet · About LEMON Manuals