Inspection Mode 7
| DTC | Item | Note |
|---|---|---|
| B1401 | M Collation NG | - |
| B1402 | Immobilizer Key Collation NG | - |
| B1407 | M Communication Abnormal | - |
| B1408 | Meter EEPROM Abnormal | - |
| B1410 | Transponder Communication Abnormal | - |
| B1411 | Immobilizer Antenna Abnormal | - |
| U1201 | CAN-HS Counter Abnormal | - |
| U0073 | Control Module Communication Bus Off | - |
| U0100 | Lost Communication With ECM/PCM "A" | - |
| U0122 | Lost Communication With Vehicle Dynamics Control Module | - |
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | - |
| U0327 | Software Incompatibility With Vehicle Security Control Module | - |
| U0401 | Invalid Data Received From ECM/PCM "A" | - |
| U0416 | Invalid Data Received From Vehicle Dynamics Control Module | - |
| U0423 | Invalid Data Received From Instrument Panel Cluster Control Module | - |
| U0427 | Invalid Data Received From Vehicle Security Control Module | - |
Diagnostic procedure:
- Perform the Clear Memory Mode.
- Read the DTC and check that the DTC is not displayed.NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. After solving the DTC, repeat from step 1.
- Turn the ignition switch OFF → ON, and wait for 10 seconds or more.
- Read the DTC and check that the DTC is not displayed.NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC.