User Customizing: Operation
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Integ. unit mode}.
- On «Integ. unit mode failure diag.» display, select {Work Support}.
- On «Work Support» display, select {Unit customizing}.
- Change the setting with UP/DOWN key and set with the [OK] key.
List of User Customizing item
Data Initial setting value Customize setting Note Off delay time 30s OFF Room light off delay time can be selected. 10 Sec 20 Sec 30s Auto Light Sensitivity Adjustment Normal Dull Slow response Normal Standard Sensitive Quick response Very sensitive Fairly quick response Rear wiper auto setting - ON OFF TPMS Setting - ((1)) TPMS Set to "ON" for model with TPMS. No TPMS Driver's Door Unlock Setting Select Select When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. ALL When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. Rear Gate Unlock Setting Select Select When the rear gate opener button is pressed, only the rear gate is unlocked. ALL When the rear gate opener button is pressed, all doors are unlocked. Rear defogger operation mode Normal Normal Automatically stops in 15 minutes after switch is turned to ON. Continuous Repeats active condition for 15 minutes and inactive condition for 2 minutes until switch is turned to OFF. Security Alarm Setup ON ON Security alarm (hazard, horn or siren) in active condition OFF Security alarm in inactive condition Impact Sensor Setup OFF ON Workable when Impact Sensor Setup is set to "ON". Impact sensor function becomes activated. OFF Impact sensor in inactive condition (Set to "OFF" in models without sensors.) Alarm delay setup ON After the keyless lock operation, the alarm monitor starts after the following delay time has passed. ON Delay time is 30 seconds. OFF Delay time is 0 second. Lockout prevention ON ON key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.) OFF Key lockout prevention function is deactivated. Impact sensor (OP) OFF ON Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "OFF" for models without the impact sensor. When "ON", hazard, horn or siren become activated by keyless lock (alarm monitor start).) OFF Vehicle is controlled in no impact sensor mode. Buzzer sounding setting ON ON When lock/unlock is selected by keyless entry system operation, buzzer operates. OFF When lock/unlock is selected by keyless entry system operation, buzzer does not operate. Abnormal warning lamp flashing setting ON ON When lock/unlock is selected by keyless entry system operation, hazard blinks. OFF When lock/unlock is selected by keyless entry system operation, hazard does not interlock. Initial keyless setting - - Execution Initial button setting - - Execution Passive Alarm OFF ON OFF Door open warning ON ON OFF Dome Light Alarm Setting OFF ON Room light illuminates interlocking with alarm. OFF Room light does not illuminate interlocking with alarm. Welcome Light Off Delay Time (Exiting) 30s OFF/30s/60 s/90 s Length of the lighting time can be set. Welcome Light Off Delay Time (Approaching) 30s OFF/30s/60 s/90 s Length of the lighting time can be set. Key less buzzer volume 5 1 - 7 Buzzer volume can be set. (1) Customization item according to the actual vehicle equipment - After setting, make sure that vehicle equipment is same as the setting changed in the {Current Data Display & Save}.CAUTION:
- The above settings must match the actual vehicle equipment.
- Do not change settings except for setting above while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".