Registration Of Keyless Transmitter With SUBARU Select Monitor

NOTE:

A maximum of four keyless transmitters can be registered for each individual vehicle.
When replacing or adding the keyless transmitter, new registration of transmitter is necessary.

Prepare the Subaru Select Monitor kit. <Ref. to SPECIAL TOOL , PREPARATION TOOL, General Description.>

Fig 1: Identifying Keyless Transmitter
Courtesy of SUBARU OF AMERICA, INC.
Prepare PC with Subaru Select Monitor installed.
Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
Connect the diagnosis cable to SDI.
Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect scan tools other than the Subaru Select Monitor.

Fig 2: Locating Keyless Transmitter Data Link Connector
Courtesy of SUBARU OF AMERICA, INC.
Start the PC.
Turn the ignition switch to OFF and run the "PC application for Subaru Select Monitor".
On the «Main Menu» of the Subaru Select Monitor, select {Each System Check} → {Integ. unit mode} → {Work Support} → {Keyless ID registration}.
According to the directions on the screen, press the button of the transmitter to be registered in the LOCK → UNLOCK order. «When registration completed, external buzzer sound once.» Repeat the registration as many times as desired.
Press the [Exit] button to finish the operations.

NOTE: When attempting to register a key that has already been registered, the external buzzer sounds twice.