CVT Model

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the brake pedal assembly.
CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:

Brake pedal: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the column assembly - steering. <Ref. to INSTALLATION , Steering Column.>
Install the panel - knee guard.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)
Install the cover assembly - instrument panel LWR driver.
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Check that the brake light operate properly.
Check the brake pedal after installation. <Ref. to INSPECTION , Brake Pedal.>