Master Cylinder: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Replace the seal sub assembly for the master cylinder assembly with a new part.
CAUTION: Be careful not to install the seal sub assembly in the wrong location.

Fig 1: Installing Seal Sub Assembly
Courtesy of SUBARU OF AMERICA, INC.
Install the master cylinder assembly.
Tightening torque:

13 N.m (1.3 kgf-m, 9.6 ft-lb)
Turn and tighten the flare nut (b) by hand while pressing the brake pipe (a) toward the master cylinder assembly side.
CAUTION: Be careful not to make scratches or other damage to the inside surface of the brake pipe flare.

Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)

Fig 2: Turning Flare Nut
Courtesy of SUBARU OF AMERICA, INC.
Bleed air from the brake system and clutch system (MT model). <Ref. to PROCEDURE , Air Bleeding.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>