Fuel Sub Level Sensor: Installation

WARNING: This page is about a different car, the 2013 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while being careful of the following.

Make sure the sealing portion is free from fuel or foreign matter before installation.
Align protrusion (A) of the gasket to the position shown in the figure.
Align protrusion (B) of the fuel sub level sensor to the cutout in the fuel sub level sensor upper plate.
Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
After tightening, install the rubber cap (C) at the position shown in the figure.
NOTE:
- Use a new gasket.
- Do not forget to install rubber cap (C).
Tightening torque:

4.4 N.m (0.4 kgf-m, 3.2 ft-lb)

Fig 1: Identifying Fuel Sub Level Sensor Upper Plate Nuts And Bolts Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating Fuel Sub Level Sensor Upper Plate To Fuel Tank Mounting Bolts And Rubber Cap
Courtesy of SUBARU OF AMERICA, INC.