LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Lighting System (Service Information)) >> Combination Switch (Light) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Switch (Light): Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U). >
  1. Install the switch assembly - combination turn dimmer.
  2. Install the switch assembly - combination wiper select.
  3. Install the steering roll connector. < Ref. to INSTALLATION , Roll Connector. >
  4. Install the cover assembly - column.
  5. Install the steering wheel.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.8 ft-lb) 

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in) 

  6. Install the driver's airbag module. < Ref. to INSTALLATION , Driver's Airbag Module. >
  7. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals