LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Anti-Theft System - Security And Locks) >> Push Button Ignition Switch >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Push Button Ignition Switch: Removal

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  2. Remove the cover assembly - instrument panel LWR driver. < Ref. to REMOVAL , Instrument Panel Lower Cover. >
  3. Remove the visor assembly - lower.
    1. Release the clips and claws.
    2. Disconnect the connector and remove the visor assembly - lower.
    CAUTION:
    • Being careful not to damage the visor assembly - lower, slowly remove the clips and claws one by one from the right and left edges of visor assembly - lower.
    • When using a clip remover, wrap it with protective tape or cloth.
    Fig 1: Identifying Lower Visor Assembly Clips And Claws
    G10272985Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the push button ignition switch.
    1. Release the claws and remove the push button ignition switch from the visor assembly - lower.
      Fig 2: Locating Push Button Ignition Switch Claws
      G10272986Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals