LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Anti-Theft System - Security And Locks) >> Security System >> Inspection >> Check Security System Condition Memory
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Security System Condition Memory

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.
  2. Close all the doors, trunk lid or rear gate.
  3. Open the front hood.
  4. Press the LOCK button of the keyless transmitter or access key.
    NOTE: Wait until the security indicator light blinks twice within 0.5 seconds at 2 second intervals.
    If the 30 second monitoring lag has been set, wait for 30 seconds.
  5. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  6. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 second intervals. When it does not blink, replace the body integrated unit.
scientia non olet · About LEMON Manuals