Engine Control Module (ECM): Installation
WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".)
NOTE:
When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the fuel injection system.
- Install the ECM bracket to the vehicle.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the connector to the ECM bracket, and install the clip securing the harness.
- Install the ECM to the ECM bracket.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Move the lock lever in the direction of the arrow, and connect the connector to the ECM in numerical order as shown in the figure.
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >