LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Fuel Injection System (H4DO)) >> Intake Manifold Assembly >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intake Manifold Assembly: Assembly

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel pipe assembly to the intake manifold assembly.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

    Fig 1: Locating Fuel Pipe Assembly
    G10262145Courtesy of SUBARU OF AMERICA, INC.
  2. Install the fuel delivery pipe to the intake manifold assembly.
    CAUTION:
    • Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
    • When connecting the quick connector, make sure to insert it all the way in before locking the slider.
    • When it is difficult to lock the slider, check that the connector is fully inserted.
    • After locking the slider, check again that the quick connector is securely connected.
    NOTE: Connect the quick connector as shown in the figure.
    Fig 2: Connecting Quick Connector
    G10307867Courtesy of SUBARU OF AMERICA, INC.
    Fig 3: Locating Manifold Absolute Pressure Sensor
    G10262143Courtesy of SUBARU OF AMERICA, INC.
  3. Install the manifold absolute pressure sensor. < Ref. to INSTALLATION , Manifold Absolute Pressure Sensor. >
  4. Install the purge control solenoid valve. < Ref. to INSTALLATION , Purge Control Solenoid Valve. >
  5. Install the EGR control valve. < Ref. to INSTALLATION , EGR Control Valve. >
  6. Install the EGR pipe. < Ref. to INSTALLATION , EGR Pipe. >
  7. Install the throttle body. < Ref. to INSTALLATION , Throttle Body. >
scientia non olet · About LEMON Manuals