Section 203 (Body Control System (Diagnostics)): Customize: List
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The setting items must match the actual vehicle equipment.
- Do not change settings except for setting below while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
| Item | Initial setting value | Setting value | Remarks | ||
|---|---|---|---|---|---|
| Off delay time | 30s | OFF 10 Sec 20 Sec 30s |
Room light off delay time can be selected. | ||
| Auto Light Sensitivity Adjustment | Sensitive | Dull Normal Sensitive Very sensitive |
Sensitivity of the automatic lighting can be adjusted. | ||
| Remote Trunk Open/Power Rear Gate Open Function | Press and hold | OFF Press twice Press and hold |
Keyless transmitter-operated trunk open/power rear gate open can be selected. | ||
| Power rear gate setting | - ((1)) |
Yes No |
Yes: Equipped with power rear gate. No: Not equipped with power rear gate. |
||
| Lane change signal setting | Yes | ON OFF |
Yes: One-touch blinker function operates. No: One-touch blinker function does not operate. |
||
| Rear wiper auto setting | Yes | ON OFF |
Yes: Rear wiper operates intermittently in sync with the reverse shift, when the front wiper is at continuous wiping. No: Rear wiper does not operate intermittently in sync with the reverse shift, when the front wiper is at continuous wiping. |
||
| Driver's Door Unlock Setting | Selection | Selection ALL |
Selection: When the touch sensor (unlock) on the driver's side is touched, only the driver's door is unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. ALL: When the touch sensor (unlock) on the driver's side is touched, all doors are unlocked. When the touch sensor (unlock) on the passenger's side is touched, all doors are unlocked. |
||
| Rear Gate Unlock Setting | Selection | Selection ALL |
Selection: When the rear gate opener button is pressed, only the rear gate is unlocked. ALL: When the rear gate opener button is pressed, all doors are unlocked. |
||
| Daytime Running Light (DRL) Setting for North America | - ((1)) |
High Beam Dimming System Low Beam Dimming System Alternate DRL System |
Set according to the daytime running light source type. | ||
| Wiper link Auto Light Setup | ON | ON OFF |
ON: Wiper interlock auto light function is activated. OFF: Wiper interlock auto light function is deactivated. |
||
| Steering Wheel | Left | Left Right |
Left: Left hand drive. Right: Right hand drive. |
||
| Vehicle Automatic Door Lock | Vehicle Speed | OFF Vehicle Speed Select Lever P |
OFF: Vehicle automatic door unlock is not activated. Vehicle speed: Vehicle automatic door lock is activated at or above a certain vehicle speed. Select lever P: Vehicle automatic door lock is activated when the select lever is shifted from P to other than P. |
||
| Vehicle Automatic Door Unlock | Driver Door Open | OFF Select Lever P Power OFF Driver Door Open |
OFF: Vehicle automatic door lock is not activated. Select lever P: Vehicle automatic door unlock is activated when the select lever is shifted from other than P to P. Power OFF: Vehicle automatic door unlock is activated when the IGN is turned from ON to OFF. Driver's door open: Vehicle automatic door unlock is activated when the driver's door is operated from Close to Open. |
||
| P/W ECU Setting | - ((1)) |
No Driver's seat Driver's seat, passenger's seat 4 seats |
No: Not equipped with power window ECM. Driver's seat: Equipped with power window ECM on driver's seat only. Driver's seat, Passenger's seat: Equipped with power window ECM only on driver's seat and passenger's seat. 4 seats: Equipped with power window ECM on all four seats. |
||
| Head Lamp Low Beam Specification | LED | Halogen HID LED |
Headlight Low beam light source information. | ||
| Head Lamp High Beam Specification | LED | Halogen HID LED |
Headlight High beam light source information. | ||
| High Beam Assist Current Setting | - ((1)) |
ON OFF |
Activated when High Beam Assist Function Setting (mirror/EyeSight) is set to other than Without HBA. ON: High beam assist is activated. OFF: High beam assist is not activated. |
||
| High Beam Assist Function Setting (mirror/EyeSight) | - ((1)) |
No EyeSight HBA mirror HBA |
Without HBA: Without HBA function. With EyeSight HBA: With HBA function by EyeSight. With mirror HBA: With HBA function by the inner mirror monocular camera. |
||
| Rear defogger operation mode | Normal | Normal Continuous |
Normal: Automatically stops in 15 minutes after the switch is turned to ON. Continuous: Repeats the cycle of 15-minute active condition and 2-minute inactive condition until the switch is turned to OFF. |
||
| Security Alarm Setup | ON | ON OFF |
ON: Warning function (hazard, horn) is activated. OFF: Warning function (hazard, horn) is deactivated. |
||
| Alarm delay setup | ON | ON OFF |
ON: The alarm monitor starts 30 seconds after the keyless lock operation. OFF: The alarm monitor starts immediately after the keyless lock operation. |
||
| Lockout prevention | ON | ON OFF |
ON: Key lockout prevention function is activated. (The function does not operate if safety knob is locked by hand.) OFF: Key lockout prevention function is deactivated. |
||
| Buzzer sounding setting | ON | ON OFF |
ON: Buzzer sounds when lock/unlock is selected by keyless entry system. OFF: Buzzer does not sound when lock/unlock is selected by keyless entry system. |
||
| Abnormal warning lamp flashing setting | ON | ON OFF |
ON: Hazard blinks when lock/unlock is selected by keyless entry system. OFF: Hazard does not blink when lock/unlock is selected by keyless entry system. |
||
| Door open warning | Yes | Yes No |
Yes: If a door stays half shut for 20 minutes, room light, map light and key ring illumination interlocked with the door go off to prevent battery run-out. No: Room light, map light, key ring illumination and door warning light remain lit with a door half shut. |
||
| Dome Light Alarm Setting | OFF | ON OFF |
ON: Room light illumination is interlocked with the alarm. OFF: Room light illumination is not interlocked with the alarm. |
||
| Auto A/C Setting | - ((1)) |
ON OFF |
ON: Equipped with auto A/C ECM. OFF: Not equipped with auto A/C ECM. |
||
| Wiper Deicer setting | - ((1)) |
ON OFF |
ON: With wiper deicer function. OFF: Without the wiper deicer function. |
||
| Sedan/Wagon Setting | - ((1)) |
Wagon Sedan |
Wagon: Wagon model. Sedan: Sedan model. |
||
| MT/AT Setting | - ((1)) |
AT MT |
AT: AT model. MT: MT model. |
||
| Illumination Sensor Setting | Yes | Yes No |
Yes: Equipped with illumination sensor. No: Not equipped with illumination sensor. |
||
| Factory initial setting | Market | Factory Market |
Factory: Factory mode. Market: Market mode. |
||
| EPB setting | Yes | Yes No |
Yes: Equipped with EPB. No: Not equipped with EPB. |
||
| Sunroof setting | - ((1)) |
Yes No |
Yes: Equipped with sunroof. No: Not equipped with sunroof. |
||
| Welcome Light (Exit) | 30s | OFF 30 Sec 60 Sec 90 Sec |
Lighting time length of the welcome lighting (exit) function can be set. | ||
| Welcome Light Off Delay Time (Approaching) | 30s | OFF 30 Sec 60 Sec 90 Sec |
Lighting time length of the welcome lighting (approaching) function can be set. | ||
| Keyless Buzzer Volume | 5 | 1 - 7 | Buzzer volume can be set. | ||
| Auto Dimmer Cancel Setting | 3 levels (standard) | 0 (OFF) Least Less Normal More Most |
Auto dimmer cancel sensitivity can be set. | ||
| Light LIN setting | - ((1)) |
Yes No |
Yes: Equipped with the front turn LED. No: Not equipped with the front turn LED. |
||
|
|||||