LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Vehicle Dynamics Control System (WRX)) >> VDC Sequence Control >> Operation >> VDC Sequence Control With SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VDC Sequence Control With SUBARU Select Monitor

WARNING: This page is about a different car, the 2013 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the event of any trouble, sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Run the "PC application for Subaru Select Monitor".
  4. Set the Subaru Select Monitor to "Brake Control System" mode.
  5. When the "VDC Inspection Mode" is selected from the "Function Check Sequence" menu, the "VDC sequence control" will start.
  6. Press the "OK" after "Press "OK"" is displayed.
  7. Operation points will be displayed on Subaru Select Monitor.
scientia non olet · About LEMON Manuals