Parameter Check

WARNING: This page is about a different car, the 2013 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The parameter data registered in the VDCCM is shown on the display.

Connect the Subaru Select Monitor.
On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Brake Control System}.
Click the [OK] button after {VDC} is displayed.
On «Brake Control Diagnosis» display, select {Confirm on parameter}.
On the {Confirm on parameter} display screen, check that the applied model and grade of the target vehicle are included, and click the [OK] button.
If the applied model and grade of the target vehicle are not included on the {Confirm on parameter} display screen, perform parameter selection and registration. < Refer to PARAMETER SELECTION , OPERATION, Subaru Select Monitor. >