Combination Base Switch Assembly: Removal

WARNING: This page is about a different car, the 2013 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Remove the driver's airbag module. < Refer to REMOVAL , Driver's Airbag Module. >
WARNING: Before handling the airbag module, refer to "CAUTION" of "General Description" in the "AB" section. < Refer to CAUTION , General Description. >
Remove the steering wheel. < Refer to REMOVAL , Steering Wheel. >
Remove the combination switch.
- Combination switch (light): < Refer to REMOVAL , Combination Switch (Light). >
- Combination switch (wiper): < Refer to REMOVAL , Combination Switch (Wiper). >
Remove the screws, and then remove the roll connector.

Fig 1: Identifying Roll Connector
Courtesy of SUBARU OF AMERICA, INC.
Remove the screws, disconnect the harness connector and remove the combination base switch assembly.

Fig 2: Locating Combination Base Switch Assembly And Screws
Courtesy of SUBARU OF AMERICA, INC.