LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Anti-Theft System - Security And Locks) >> Impact Sensor >> Operation >> Impact Sensor Setting Using SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Impact Sensor Setting Using SUBARU Select Monitor

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prepare the Subaru Select Monitor kit.
  2. Turn the ignition to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  3. On «System Selection Menu» display, select «Integ. unit mode».
  4. On «Work Support» display, select «Unit customizing».
  5. Make an impact monitor setting.
    • When installing: ON
    • When removing: OFF
  6. Make an impact monitor ON/OFF setting.
    • When installing: ON
    • When removing: OFF
  7. Turn the ignition to OFF, and then remove the Subaru Select Monitor.
scientia non olet · About LEMON Manuals