LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Anti-Theft System - Security And Locks) >> Keyless Entry System >> Inspection >> Check Keyless Entry Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Keyless Entry Control Module

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTICS PROCEDURE

Step Check Yes No
1 CHECK BODY INTEGRATED UNIT. 
Read the DTC using Subaru Select Monitor.
NOTE: For detailed procedures, refer to "PC application help for Subaru Select Monitor".
 Is DTC B1500 "KEYLESS UART COM. MALFUNCTION" displayed? Go to step 2  . Keyless entry control module is normal.
2 CHECK POWER SUPPLY. 
  1. Disconnect the keyless entry control module connector.
  2. Measure the voltage between keyless entry control module connector and chassis ground.

    Connector & terminal 

    (R221) No. 6 (+) - Chassis ground (-): 

 Is the voltage 10 V or more? Go to step 3  . Check the harness for open or short circuits between the keyless entry control module and the fuse.
3 CHECK GROUND CIRCUIT. 
Measure the resistance between keyless entry control module connector and chassis ground.
Connector & terminal 
(R221) No. 5 - Chassis ground: 		 Is the resistance less than 10 Ω? Go to step 4  . Repair or replace the harness.
4 CHECK KEYLESS ENTRY CONTROL MODULE CIRCUIT. 
  1. Disconnect the body integrated unit connector.
  2. Check the harness between keyless entry control module and body integrated unit.

    Connector & terminal 

    (i81) No. 11 - (R221) No. 11: 

 Is harness normal? Replace the keyless entry control module. Repair or replace the harness.
scientia non olet · About LEMON Manuals