Rear Lock Button: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure that the harness grommet is securely installed.
If not properly installed, this may cause leaks.
If not properly installed, this may cause leaks.
- Install the rear lock button and the switch - opener rear gate.
- Install the garnish assembly - rear gate. <Ref. to
INSTALLATION
, Rear Gate Garnish.>
Tightening torque
4.5 N.m (0.4 kgf-m, 3.3 ft-lb)
- Install the trim panel - rear gate. <Ref. to INSTALLATION , Rear Gate Trim.>
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>