LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (General Information) >> Repair Contents >> Note >> On The Car Wheel Balancing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On The Car Wheel Balancing

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Carry out the procedures after measuring the balance of each single tire.
  • Set the vehicle so that the front and rear wheels are the same height.
  • Make sure that the VDC is deactivated.
  • Release the parking brake during measurement.
  • Rotate each wheel by hands, and make sure it rotates without dragging.
  • Do not operate the clutch quickly and do not accelerate or decelerate suddenly during work.
  • When an error is indicated during engine drive, do not use the motor drive together.
  1. Set the rigid rack to the specified locations of side sill, jack up the front or rear two wheels of non-measuring side and set the pickup stands to two wheels of measuring side.
    Fig 1: Supporting Vehicle Front/Rear Wheels Using Jack
    G10262016Courtesy of SUBARU OF AMERICA, INC.
  2. For drive wheel, drive the tires with engine for measurement.
  3. For non-drive wheel, drive the tires from the on the car wheel balancer for measurement.
scientia non olet · About LEMON Manuals