LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Lighting System) >> Combination Switch (Light) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Switch (Light): Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" article. <Ref. to CAUTION , General Description.>
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U).>
  1. Install the switch assembly - combination turn dimmer.
  2. Install the combination switch (wiper).
  3. Install the steering roll connector. <Ref. to INSTALLATION , Roll Connector.>
  4. Install the cover assembly - column.
  5. Install the steering wheel.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.8 ft-lb) 

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in) 

  6. Install the driver's airbag module. <Ref. to INSTALLATION , Driver's Airbag Module.>
  7. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
scientia non olet · About LEMON Manuals