Knock Sensor: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block, and connect the connector to the knock sensor.
NOTE:
- Install the knock sensor connector so that the center of the connector is aligned with the extension line from the cylinder block rib (a).
- Make sure that the knock sensor and its connector do not touch the adjacent parts.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Locating A/C Compressor Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the bolt securing the connector to the A/C compressor.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>