How To Proceed With Troubleshooting
NOTE:
- Use the following procedures to troubleshoot the power door lock control system.
- *: Use the SSM3.
- Vehicle Brought To Workshop
NEXT
- Inspect Battery Voltage
Standard voltage: 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Next
- Problem Symptoms Table
- Refer to PROBLEM SYMPTOMS TABLE
.
Result
Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B B: Go to step 5
A: Go to next step
- Refer to PROBLEM SYMPTOMS TABLE
.
- Overall Analysis And Troubleshooting*
- ECM terminal arrangement (See ECM TERMINAL ARRANGEMENT ).
- Operation check (See OPERATION CHECK ).
- Data List/Active Test (See CURRENT DATA DISPLAY & SAVE/SYSTEM OPERATION CHECK MODE
).
Next
- Adjust, Repair Or Replace
Next
- Confirmation Test
Next: End