Intake Manifold Assembly (Fa20): Installation

1. Install the 2 new gaskets to the intake manifold.
2. Install the intake manifold with the 6 bolts.

   Standard value: T=25N.m {255kgf.cm} {18.4ft.lbf}

3. Engage the 2 clamps.
4. Engage the 4 connectors and connect the wire harness.
5. Connect the fuel pump connector.
6. Engage the clamp and connect the engine wire harness.
7. Engage the 5 clamps and connect the battery cable.
8. Connect the purge control solenoid valve connector.
9. Connect the manifold absolute pressure sensor connector.

1. Connect the ventilation hose.

1. Engage the 3 claws and install the No. 1 engine cover sub-assembly.

1. Connect the No. 2 fuel vapor feed hose.
2. Install the bolt and connect the fuel delivery pipe sub-assembly.

   Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

1. Install a new gasket to the intake manifold.
2. Install the 4 bolts and throttle with motor body assembly to intake manifold.

   Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}

Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}