Inspection steps
WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Check neutral start switch circuit.
- Disconnect the connector for neutral start switch ASSY.
- Turn the ignition switch to ON.
- Measure the voltage between the terminals.
VOLTAGE
| Inspection terminals |
Inspection conditions |
Standard value |
| L2-5 - chassis ground |
Always |
10V or more |
NG: Repair or replace the harness.
OK: Go to Next Step
- Check neutral start switch circuit.
- Turn the ignition switch to OFF.
- Measure the resistance between the terminals.
RESISTANCE
| Inspection terminals |
Inspection conditions |
Standard value |
| L2-5 - chassis ground |
Always |
Less than 10 Ω |
NG: Repair or replace the harness.
OK: Go to Next Step
- Check neutral start switch.
- Perform a unit inspection of neutral start switch.
Criteria: No fault is found.
NO: Replace neutral start switch.
YES: Replace the ECM.