Cancel code reading

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

OPERATION
1. Connect the SSM3 to the DLC3.
2. Start the engine.
3. Turn on the SSM3.
4. Select from the following menu items: [Each System Check]/[Engine System Control]/[Cancel Code(s) Display]
5. Drive vehicle at 40 km/h {25 MPH} or more and set the cruise control.
  CAUTION:
  - When performing diagnosis, observe the legal speed limit on the road.
  - The cancel code will also appear when the cruise control is cancelled by the driver's operation. Do not confuse them.
  - Be sure to get an assistant to support the diagnosis while driving, and have him/her operate the select monitor.
6. When the set speed is cancelled by itself (when cancelled without a cancel operation such as applying the brake) or if the cruise control could not be set by performing the setting operation, selecting the [Cancel Code(s) Display] on the engine malfunction diagnosis screen will display the cancel code on the select monitor display.
  NOTE: The [Latest Diagnostic Code(s)] and [Memorized Diagnostic Code(s)] are contained in the cancel code. The latest code recognized during current test drive is displayed in [Latest Diagnostic Code(s)]. Cancel codes resulting from fault diagnosis of switches relating to the system and cruise control are also displayed in [Memorized Diagnostic Code(s)].
7. Perform Engine DTC Clear Memory operation. Cancel codes for switches relating to the system and cruise control are deleted by clearing memory on the engine side.
  NOTE:
  - The latest code will be cleared by turning ignition switch to OFF.
  - For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
  - For details on cancel codes, refer to LIST OF CANCEL CODES .