Data list diagnostics

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

OPERATION
1. Connect the SSM3 to the DLC3.
2. Start the engine.
3. Turn on the SSM3.
4. Select from the following menu items: [Each System Check]/[Engine System Control]/[Current Data Display & Save]
5. Make sure that normal display is shown when operated as follows:
  - Depress and release the brake pedal. (Stop light switch and brake switch turn ON).
  - Turn the "ON-OFF" switch to ON.
  - Turn the "-SET" switch to ON.
  - Turn the "+RES" switch to ON.
  - Turn the "CANCEL" switch to ON.
  - Depress or release the clutch switch.
  - Place the shift lever in any position other than neutral.
  NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".