LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> Crosstrek Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Security And Locks) >> Door Lock Control System >> Inspection >> Check Door Lock Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Door Lock Switch

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
Step Check Yes No
1 CHECK CURRENT DATA. 
Using the Subaru Select Monitor, display the data of «Manual lock SW input».
NOTE: For detailed procedures, refer to "PC application help for Subaru Select Monitor".
 Does the display switch between OFF ←→ ON when each door lock switch is moved to LOCK? Go to step 2  . Go to step 3  .
2 CHECK DOOR LOCK SWITCH. 
From the condition in step 1), operate each door lock switch (driver's and passenger's) in the UNLOCK direction.		 Does the display switch between OFF ←→ ON? The door lock switch is OK. Go to step 4  .
3 CHECK POWER WINDOW MAIN SWITCH (DOOR LOCK SWITCH). 
  1. Disconnect the power window main switch (door lock switch) connector.
  2. Measure the continuity between terminals when moving the power window main switch (door lock switch) in LOCK direction.

    Terminals Driver's side (D7) No. 2 - (D1002) No. 3: 

    Passenger's side (D125) No. 4 - (D125) No. 5: 

 Did the indicator change from "No continuity" (1 MΩ or more) to "Continuity exists" (less than 10 Ω)? Go to step 4  . Replace the power window main switch or door lock switch.
4 CHECK POWER WINDOW MAIN SWITCH (DOOR LOCK SWITCH). 
Measure the continuity between terminals when moving the power window main switch (door lock switch) in UNLOCK direction.
Terminals Driver's side (D7) No. 2 - (D102) No. 3: 
Passenger's side (D125) No. 2 - (D125) No. 5: 		 Did the indicator change from "No continuity" (1 MΩ or more) to "Continuity exists" (less than 10 Ω)? Go to step 5  . Replace the power window main switch or door lock switch.
5 CHECK HARNESS. 
Measure the resistance between the power window main switch (door lock switch) connector and chassis ground.
Connector & terminal Driver's side (D102) No. 3 - Chassis ground: 
Passenger's side (D125) No. 5 - Chassis ground: 		 Is the resistance less than 10 Ω? Go to step 6  . Repair or replace the harness.
6 CHECK HARNESS. 
Check the harness between body integrated unit and power window main switch (door lock switch).
Connector & terminal Driver's side (D7) No. 10 - (i84) No. 9: 
(D7) No. 2 - (i84) No. 20: 
Passenger's side (D125) No. 4 - (i84) No. 9: 
(D125) No. 2 - (i84) No. 20: 		 Is harness normal? Replace the body integrated unit. < Ref. to BODY INTEGRATED UNIT .> Repair or replace the harness.
scientia non olet · About LEMON Manuals