Push Button Ignition Switch: Inspection
WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
On the vehicle inspection
Preparation tool:
Circuit tester
- Check the continuity between push button ignition switch terminals.
Terminal No. Inspection conditions Specification Connection diagram 4 (COM) - 5 (GND) Always Continuity exists 7 (SSW1) - 5 (GND) Push button ignition switch released → pressed Continuity exists 2 (SSW2) - 5 (GND) Push button ignition switch released → pressed Continuity exists - Check the push button ignition switch operation when battery voltage is applied between the terminals of the push button ignition switch.
Terminal No. Inspection conditions Specification Connection diagram 11 (SWIL) - 5 (GND) Connect battery to the terminals Goes off → Red switch illumination light 12 (INDS) - 5 (GND) Turns off → Switch indicator lights in green 13 (INDW) - 5 (GND) Turns off → Switch indicator lights in orange - Replace the push button ignition switch if the inspection result is not within the standard value.