LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> Crosstrek Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Body Control System (Diagnostics)) >> User Customizing >> Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

User Customizing: Operation

WARNING: This page is about a different car, the 2015 Subaru XV Crosstrek and 2015 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. On «Main Menu» display, select {Each System Check}.
  2. On «System Selection Menu» display, select {Integ. unit mode}.
  3. On «Integ. unit mode failure diag.» display, select {Work Support}.
  4. On «Work Support» display, select {Unit customizing}.
  5. Change the setting with UP/DOWN key and set with the [OK] key.

    List of User Customizing item

    Data Initial setting value Customize setting Remarks
    Off delay time 30s OFF Room light off delay time can be selected.
    10s
    20s
    30s
    Auto Light Sensitivity Adjustment Normal Dull Slow response
    Normal Standard
    Sensitive Quick response
    Very sensitive Fairly quick response
    Power rear gate setting - ((1)) ON Fixed at OFF because this is not applicable.
    OFF
    Lane change signal setting ON ON One-touch blinker control is performed.
    OFF One-touch blinker control is not performed.
    Rear wiper auto setting - ON Existence of a rear wiper linked with reverse operation can be set.
    OFF
    TPMS Setting - ((1)) TPMS Set to "ON" for model with TPMS.
    No TPMS
    Driver's Door Unlock Setting Selection Selection The door to be unlocked when you touch the driver's door can be set.
    ALL
    Rear Gate Unlock Setting Selection Selection The door to be unlocked when you touch the R gate switch can be set.
    ALL
    One-touch Turn Signal System Setup ON ON ON/OFF of the one-touch blinker can be set.
    OFF
    Auto Wiper System (Rear) Setup OFF ON ON/OFF of the rear wiper linked with reverse operation can be set.
    OFF
    Steering Responsive Fog Lamp Setting OFF ON SRF control is performed.
    OFF SRF control is not performed.
    Rear defogger operation mode Normal Normal Automatically stops in 15 minutes after the switch is turned to ON.
    Continuous Repeats activated for 15 minutes and deactivated for 2 minutes until the switch is turned to OFF.
    Security Alarm Setup ON ON Security alarm (hazard, horn or siren) becomes activated.
    OFF Security alarm becomes deactivated.
    Impact Sensor Setup OFF ON Workable when the Impact Sensor Setup is set to "ON". Impact sensor function becomes activated.
    OFF Impact sensor function becomes deactivated. (Be sure to set to "OFF" for models without sensors.)
    Alarm delay setup ON   After the keyless lock operation, the alarm monitor starts after the following delay time has passed.
    ON Delay time is 30 seconds.
    OFF Delay time is 0 seconds.
    Lockout prevention ON ON Key lockout prevention function is activated. (This function does not operate if safety knob is locked by hand.)
    OFF Key lockout prevention function is deactivated.
    Impact sensor (OP) OFF ON Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "OFF" for models without the impact sensor. When set to "ON", hazard, horn or siren become activated by keyless lock (alarm monitor start).)
    OFF Vehicle is controlled in impact sensor non-equipped mode.
    Buzzer sounding setting ON ON Buzzer operates when lock/unlock is selected by keyless entry system operation.
    OFF Buzzer does not operate when lock/unlock is selected by keyless entry system operation.
    Abnormal warning lamp flashing setting ON ON Hazard blinks when lock/unlock is selected by keyless entry system operation.
    OFF Hazard is not interlocked when lock/unlock is selected by keyless entry system operation.
    Passive Alarm OFF ON  
    OFF  
    Door open warning ON ON  
    OFF  
    Dome Light Alarm Setting OFF ON Room light illuminates interlocking with alarm.
    OFF Room light does not illuminate interlocking with alarm.
    Auto A/C ECU Setting - ((1)) ON Diagnoses with auto A/C Control Module.
    OFF Diagnoses without auto A/C Control Module.
    wiper deicer -((1)) ON Wiper deicer control is performed.
    OFF Wiper deicer control is not performed.
    Illumination Control On/Off ON ON  
    OFF  
    Sedan/Wagon Setting - ((1)) SEDAN Body control is performed for Sedan.
    WAGON Body control is performed for Wagon.
    MT/AT Setting - ((1)) MT Body control is performed for MT.
    AT Body control is performed for AT.
    6MT Setting - ((1)) 6MT Body control is performed for 6MT.
    Other than 6MT Body control is performed for other than 6MT.
    Illumination Sensor Setting - ((1)) ON Set to "ON" for model with auto light.
    OFF
    Factory initial setting Market Market Customize setting is reset when mode is switched from Market to Factory.
    Factory
    Welcome Light Off Delay Time(Exiting) 30s OFF Length of the lighting time can be set.
    30s
    60s
    90s
    Welcome Light Off Delay Time(Approaching) 30s OFF Length of the lighting time can be set.
    30s
    60s
    90s
    Keyless Buzzer Volume 5 1 - 7 Buzzer volume can be set.
    (1) Customization item according to the actual vehicle equipment
  6. After setting, make sure that the setting changed in the {Current Data Display & Save} is same as vehicle equipment.
    CAUTION:
    • The above settings must match the actual vehicle equipment.
    • Do not change settings except for setting above while setting the functions.
    • Be sure not to change Factory initial setting except when installing a new body integrated unit.
    NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
scientia non olet · About LEMON Manuals