Steering Lock Control Module: Installation
CAUTION:
- Registration of the immobilizer is necessary when a immobilizer-related control module has been replaced. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U). >
- Secure the steering lock control module to the steering column.
- Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
- Install the column assembly - steering.
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >