Section 35 (Front Suspension And Wheel Alignment): Stabilizer: Installation: Stabilizer
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- For parts which are not reusable, always use new parts.
- Install the rubber bushing stabilizer front so that the slit does not shift to the right or left.
- Install the clamp stabilizer with the peak of triangle facing the front of the vehicle.
NOTE:
The rubber bushing stabilizer front can be used with its slit facing either front or rear.
- Install the stabilizer front, the rubber bushing stabilizer front, and the clamp stabilizer.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the stabilizer link front (bottom part). Ref. to FRONT SUSPENSION>STABILIZER>INSTALLATION>STABILIZER LINK .
- Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
- Install the crossmember support rear LH. Ref. to FRONT SUSPENSION>CROSSMEMBER SUPPORT>INSTALLATION .
- Install the under guard front. Ref. to EXTERIOR/INTERIOR TRIM >FRONT UNDER COVER>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .