LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Electrical >> Starter >> Entry Start System Start System (Keyless Start) >> Entry & start system (start function) >> DTC Check/Clear
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check/Clear

CAUTION: If the SSM4 is connected to the vehicle with the engine switch off, the information stored in entry and start system related ECMs (the certification ECM and main body ECM) cannot be read. However, entry and start system DTCs and [Data monitor] information can be confirmed even if the engine switch is off using the method below:
  1. CHECK DTC (POWER SOURCE CONTROL)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Keyless Access(Power Supply ECM)] →[DTC]
    5. Check for DTCs.
      NOTE: Refer to the SSM4 operator's manual for further details.
  2. CHECK DTC (ENTRY AND START)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Keyless Access(Collation ECM)] →[DTC]
    5. Check for DTCs.
      NOTE: Refer to the SSM4 operator's manual for further details.
  3. CHECK DTC (ENGINE AND ECT)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Engine Control System] →[DTC]
    5. Check for DTCs.
      NOTE: Refer to the SSM4 operator's manual for further details.
  4. CLEAR DTC (POWER SOURCE CONTROL)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Keyless Access(Power Supply ECM)] →[DTC] →[Clear Memory]
    5. Clear the DTCs by following the directions on the SSM4 display.
      NOTE: Refer to the SSM4 operator's manual for further details.
  5. CLEAR DTC (ENTRY AND START)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Keyless Access(Collation ECM)] →[DTC] →[Clear Memory]
    5. Clear the DTCs by following the directions on the SSM4 display.
      NOTE: Refer to the SSM4 operator's manual for further details.
  6. CLEAR DTC (ENGINE AND ECT)
    1. Connect the SSM4 to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the SSM4 on.
    4. Enter the following menus: [Engine Control System] →[DTC] →[Clear Memory]
    5. Clear the DTCs by following the directions on the SSM4 display.
      NOTE: Refer to the SSM4 operator's manual for further details.
scientia non olet · About LEMON Manuals