Data monitor/active test
- DATA LISTNOTE: Using the SSM4 to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.CAUTION: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the SSM4 to the DLC3.
- Turn the ignition switch to ON.
- Turn the SSM4 on.
- Enter the following menus: [Each System Check]/[Combination Meter]/[Data monitor], [Each System Check]/[Airbag]/[Data monitor], [Each System Check]/[Occupant Detection]/[Data monitor]
- Read the Data List according to the display on the SSM4.
COMBINATION METER (COMBINATION METER ASSEMBLY)Tester Display Measurement Item/Range Normal Condition Diagnostic Note [Driver Side Seatbelt Warning Buzzer] Driver seat belt warning buzzer/ON or OFF Customized value displayed - [P-Seatbelt Warning Buzzer] Front passenger seat belt warning buzzer/ON or OFF Customized value displayed - OCCUPANT DETECTION (OCCUPANT DETECTION ECU)Tester Display Measurement Item/Range Normal Condition Diagnostic Note [Status of Passenger Side Buckle SW] Front passenger buckle switch/ON or OFF Unset: Seat belt not fastened
Set: Seat belt fastened
NG: Data is not determined- AIRBAG CONTROL MODULETester Display Measurement Item/Range Normal Condition Diagnostic Note [Status of Passenger Side Buckle SW] Front passenger buckle switch/ON or OFF Unset: Seat belt not fastened
Set: Seat belt fastened
NG: Data is not determined- - ACTIVE TEST
Using the SSM4 to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the SSM4 to the DLC3.
- Turn the ignition switch to ON.
- Turn the SSM4 on.
- Enter the following menus: [Each System Check]/[Combination Meter]/[Active Test]
- Perform the Active Test according to the display on the SSM4.
COMBINATION METER (COMBINATION METER ASSEMBLY)Tester Display Test Part Control Range Diagnostic Note [Driver Side Seat Belt] Seat belt warning light OFF/ON - [Front passenger Side Seat Belt] Seat belt warning light OFF/ON -