Cruise Control Command Switch: Inspection
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard 3 - 9 {CANCEL}
{SET}/-
SET/+All OFF Approx. 4, 020 Ω {CANCEL} {ON} Less than 1 Ω {SET}/- {ON} Approx. 250 Ω SET/+ {ON} Approx. 1, 470 Ω 4 - 9 {CRUISE}
(MAIN){OFF} 1 MΩ or more {ON} Less than 1 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. Inspection conditions Specification 10 (+) - 11 (-) Apply battery voltage. Light ON - Replace the cruise control command switch assembly if it is found defective.