Basic Diagnostic Procedure: Procedure

1. Ask the customer when and how the trouble occurred using the interview check list. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Check List for Interview .
2. Before performing diagnostics, check the component which might affect VDC problems. Ref. to BRAKE CONTROL (DIAGNOSTICS)>General Description>INSPECTION .

Is the check result OK?

• Yes  : Go to 2. 
• No  : Repair or replace each component.

1. Turn the ignition switch to OFF.
2. Connect the Subaru Select Monitor to data link connector.
3. Turn the ignition switch to ON and run the Subaru Select Monitor.
4. Read the DTC using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC) .
   NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Subaru Select Monitor>INSPECTION>COMMUNICATION FOR INITIALIZING IMPOSSIBLE .

Is DTC displayed on Subaru Select Monitor?

• Yes  : Record the DTC, time stamp and freeze frame data. Go to  4.
  NOTE:

  • For the time stamp, refer to LAN information. Ref. to LAN SYSTEM (DIAGNOSTICS)>General Description>CAUTION>TIME STAMP .
  • Depending on DTCs, time stamp may not be stored.
• No: Go to 3. 

1. Perform the inspection by referring to "General Diagnostic Table". Ref. to BRAKE CONTROL (DIAGNOSTICS)>General Diagnostic Table .
2. Clear the memory. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Clear memory .
3. Perform the Inspection Mode. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Inspection Mode .
4. Read the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC) .
5. Check that the DTC is not displayed.

Do the VDC warning light & VDC indicator light, VDC OFF indicator light and ABS warning light go off after starting the engine?

• Yes  : Finish the diagnosis.
• No  : Check the combination meter circuit. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Warning Light Illumination Pattern>ABS WARNING LIGHT DOES NOT GO OFF . Ref. to BRAKE CONTROL (DIAGNOSTICS)>Warning Light Illumination Pattern>VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT GO OFF . Ref. to BRAKE CONTROL (DIAGNOSTICS)>Warning Light Illumination Pattern>VDC OFF INDICATOR LIGHT DOES NOT GO OFF .

1. Refer to "List of Diagnostic Trouble Code (DTC)".
   NOTE: For the DTC list, refer to "List of Diagnostic Trouble Code (DTC)". Ref. to BRAKE CONTROL (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC) .
2. Correct the cause of trouble.
3. Clear the memory. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Clear memory .
4. Perform the Inspection Mode. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Inspection Mode .
5. Read the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC) .

Is DTC displayed?

• Yes  : Repeat step 4 until DTC is not shown.
• No  : Finish the diagnosis.