| (R422) No. 1 (+B) ←→ Chassis ground |
Voltage |
Always |
10.5 - 16 V |
| (R422) No. 2 (SW-V) ←→ Chassis ground |
Voltage |
Always |
10.5 - 16 V |
| (R422) No. 3 (CLUTCH (GND)) ←→ Chassis ground |
Resistance |
Always |
Less than 1 Ω |
| (R422) No. 4 (SOL (-)) ←→ Chassis ground |
Voltage |
During solenoid cancellation output |
Less than 1 V |
| (R422) No. 5 (CLOSER (OPEN)) ←→ Chassis ground |
Voltage |
When power rear gate auto closer is performing the release operation |
10.5 - 16 V |
| (R422) No. 6 (SOL (COMMON)) ←→ Chassis ground |
Voltage |
Always |
10.5 - 16 V |
| (R422) No. 7 (MOTOR (CLOSE)) ←→ Chassis ground |
Voltage |
When auto-close is in operation |
10.5 - 16 V |
| (R422) No. 8 (+POWER B) ←→ Chassis ground |
Voltage |
Always |
10.5 - 16 V |
| (R422) No. 9 (SEN-V) ←→ Chassis ground |
Voltage |
Always |
4 - 6 V |
| (R422) No. 10 (IGN) ←→ Chassis ground |
Voltage |
When ignition switch is ON |
10.5 - 16 V |
| (R422) No. 11 (CLUTCH (+)) ←→ Chassis ground |
Voltage |
When auto-close is in operation |
10.5 - 16 V |
| (R422) No. 12 (SOL (BUZZER)) ←→ Chassis ground |
Resistance |
When buzzer is OFF |
Less than 1 Ω |
| (R422) No. 13 (CLOSER (CLOSE)) ←→ Chassis ground |
Voltage |
When power rear gate auto closer is in pull-in operation |
10.5 - 16 V |
| (R422) No. 14 (P-GND) ←→ Chassis ground |
Resistance |
Always |
Less than 1 Ω |
| (R422) No. 15 (MOTOR (OPEN)) ←→ Chassis ground |
Voltage |
When auto-open is in operation |
10.5 - 16 V |
| (R422) No. 16 (SOL (+)) ←→ Chassis ground |
Voltage |
When solenoid lock is output |
Less than 1 V |
| (R423) No. 1 (LIN) ←→ Chassis ground |
- |
Cannot be measured (LIN communication line) |
- |
| (R423) No. 2 (HALF STOP SW) ←→ Chassis ground |
Voltage |
When memory height switch is ON |
10.5 - 16 V |
| (R423) No. 3 (SOL POS SW) ←→ Chassis ground |
Voltage |
Except for PRG at half-stop state |
4 - 6 V |
| (R423) No. 4 (SECTOR SW) ←→ Chassis ground |
Voltage |
When PRG is fully closed |
Less than 1 V |
| (R423) No. 5 (-) ←→ Chassis ground |
- |
- |
- |
| (R423) No. 6 (GATE SW) ←→ Chassis ground |
Voltage |
When PRG inner SW is ON |
10.5 - 16 V |
| (R423) No. 7 (-) ←→ Chassis ground |
- |
- |
- |
| (R423) No. 8 (S-GND) ←→ Chassis ground |
Resistance |
Always |
Less than 1 Ω |
| (R423) No. 9 (-) ←→ Chassis ground |
- |
- |
- |
| (R423) No. 10 (SEN-A) ←→ Chassis ground |
Voltage |
When PRG is stopped |
4 - 6 V |
| (R423) No. 11 (T-SEN R) ←→ Chassis ground |
Voltage |
When sensor is ON |
Less than 1 V |
| (R423) No. 12 (T SEN L) ←→ Chassis ground |
Voltage |
When sensor is ON |
Less than 1 V |
| (R423) No. 13 (LATCH SW) ←→ Chassis ground |
Voltage |
When PRG is fully closed |
4 - 6 V |
| (R423) No. 14 (COURTESY SW) ←→ Chassis ground |
Voltage |
When PRG is fully closed |
4 - 6 V |
| (R423) No. 15 (HAZARD) ←→ Chassis ground |
Voltage |
When hazard switch is OFF |
Less than 1 V |
| (R423) No. 16 (D SW) ←→ Chassis ground |
Voltage |
When driver's switch is ON |
10.5 - 16 V |
| (R423) No. 17 (-) ←→ Chassis ground |
- |
- |
- |
| (R423) No. 18 (T-SEN GND) ←→ Chassis ground |
Resistance |
Always |
Less than 1 Ω |
| (R423) No. 19 (SEN-GND) ←→ Chassis ground |
Resistance |
Always |
Less than 1 Ω |
| (R423) No. 20 (SEN-B) ←→ Chassis ground |
Voltage |
When PRG is stopped |
4 - 6 V |