LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> Impreza Base, 4D Sedan, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostics - Introduction) >> Inspection Mode >> Procedure >> Inspection Mode A >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. Using the Subaru Select Monitor, clear the memory of [Engine Control System].
  3. Execute the inspection mode. Ref. to ENGINE (DIAGNOSTICS) >Inspection Mode .
    NOTE: Perform the inspection mode after warming up the engine except when the engine coolant temperature at engine start is specified.
  4. Drive for 20 minutes or more at a constant speed of 80 km/h (50 MPH) or more.
  5. Stop the vehicle and idle for one minute.
  6. Read the readiness code of [Engine Control System] using Subaru Select Monitor and check that the concerned DTC is completed. Ref. to ENGINE (DIAGNOSTICS) >All Readiness Diagnostic Code(s) .
  7. Read the DTC of [Engine Control System] using the Subaru Select Monitor. Ref. to ENGINE (DIAGNOSTICS) >Diagnostic Trouble Code (DTC) .
  8. Read the temporary code using the Subaru Select Monitor or general scan tool.
scientia non olet · About LEMON Manuals