Fuel Pump Control Unit: Installation
WARNING: This page is about a different variant/trim than selected.
- Connect the connector to the fuel pump control module.
- Install the fuel pump control module.
Tightening torque:
5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Install the trunk trim panel assembly - side on RH side. (Sedan model) <Ref. to INSTALLATION , Rear Quarter Trim.>
- Install the right side rear quarter trim. (OUTBACK model) <Ref. to INSTALLATION , Rear Quarter Trim.>
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>