Check Trunk Opener Switch Circuit

Step	Check	Yes	No
1 CHECK DATA MONITOR . Using the Subaru Select Monitor, display the data of «R Gate Release SW input». NOTE: For detailed operation procedures, refer to "Application help".	Does the display switch between OFF ← → ON when the trunk opener switch is operated?	The trunk opener switch is normal.	Go to step 2 .
2 CHECK HARNESS . Disconnect the connectors of body integrated unit and trunk opener switch. Check the harness between the body integrated unit and trunk opener switch. Connector & terminal (i84) No. 10 - (i13) No. 1:	Is harness normal?	Go to step 3 .	Repair or replace the harness.
3 CHECK HARNESS . Measure the resistance between the trunk opener switch connector and chassis ground. Connector & terminal (i13) No. 2 - Chassis ground:	Is the resistance less than 10 Ω?	Go to step 4 .	Repair or replace the harness.
4 CHECK TRUNK OPENER SWITCH . Measure the resistance between terminals both when trunk opener switch is pressed and when not pressed. Terminals No. 2 - No. 3:	Is the resistance less than 10 Ω when the switch is pressed and 1 MΩ or more when not pressed?	Replace the body integrated unit. <Ref. to BODY INTEGRATED UNIT .>	Replace the trunk opener switch.