Push Button Ignition Switch: Inspection

Check the continuity between the connectors.

Preparation tool:

Circuit tester

Fig 1: Push Button Ignition Switch Connector Terminal

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
4 (COM) - 5 (GND)	Always	Continuity exists
7 (SSW1) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists
2 (SSW2) - 5 (GND)	Push button ignition switch released → pressed	Continuity exists

Check the push button ignition switch operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Specification
11 (SWIL) - 5 (GND)	Connect battery to the terminals	Goes off → Red switch illumination light
12 (INDS) - 5 (GND)		Turns off → Switch indicator lights in green
13 (INDW) - 5 (GND)		Turns off → Switch indicator lights in orange

Replace the push button ignition switch if the inspection result is not within the standard value.