Position Is Not Memorized (Automatic Open/Close Cannot Be Performed)
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
«Position learning»
- Position the lid assembly at the fully tilt up position, and press and hold the tilt up switch for ten seconds.
- The motion of the glass lid shifts to inching operation until it reaches the mechanical lock position (further tilt up position than the fully tilt up position). After the mechanical lock, it returns to the fully tilt up position and then stops.
- Release the tilt up switch to finish the position learning.
«Sliding learning»
- Within six seconds after the position learning is finished, press and hold the tilt up switch again.
- The lid assembly moves to the full close position, full open position, and the full close position successively, and stops at the full close position.
- Release the tilt up switch and turn the ignition switch to OFF to finish the initializing.